Skip to content

Tounch screen stop working after couple seconds without touched

2014/04/29

While installed Windows 8.1 on my Gigabyte latop T1125N, I found the touch screen didn’t work properly. As long as I didn’t touch it after couple seconds, then it didn’t work anymore until reboot.
I check the device (CANDO PCAP MultiTouch Digitizer) in device management console, I found I could make it back by removing and then adding it back or re-enable it. In the end, there is a power saving tab in the device property. I disabled the option “allow computer to turn off this device to save power" which is enable by default. Then my touch screen work normally again.

If you have encountered this issue, hope my experience would help you to resolve the problem.

From → Windows

發表迴響

發表迴響

在下方填入你的資料或按右方圖示以社群網站登入:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / 變更 )

Twitter picture

You are commenting using your Twitter account. Log Out / 變更 )

Facebook照片

You are commenting using your Facebook account. Log Out / 變更 )

Google+ photo

You are commenting using your Google+ account. Log Out / 變更 )

連結到 %s

%d 位部落客按了讚: